Tags
This 7-day programmable thermostat is designed for floor warming application or helping to limit floor temperature. This thermostat can conform to electrical heating or water heating system.
Designed to give automatic temperature control of domestic wet central heating systems.It can be used to directly switch a circulating pump or boiler,or to operate spring return motor/open motor/close zone valves. The thermostat can switch electrical heating loads up to 10A.
The waterline heating controller has been developed to provide a temperature control system for room heating,intergrating the switching of primary heating source also to control any secondary pumps or zone valves.
The Heatmiser neoStat is a 230v powered thermostat with a volt free switch. The neoStat is designed to communicate with the neoHub and other neoStats within your home, to create a fully controllable network system of your home heating. The neoStat can be configured to work as a thermostat or as a timer- so if you want to take control of your towel rails,...
The UH4 is also ideally suited for underfloor heating but can also control a single zone of radiators. The UH4 provides central switching of up to 4 zone actuators Output for a hot water cylinder and the system boiler and pump. UH4 Dimensions 384x148x60mm
Up to 8 zones can be controlled from the UH8. On board the UH8 are two heating time channels, each zone allows you to specify which time channel it should follow.
A strip to control floor heating actuators, intended for installation in electrical cabinets. AURATON 4D PRO works with cable temperature controllers. It enables simultaneous control of the operation of the central heating pump and of the heating device